I already have the mcal code and SDK based on AM62Px, but I don't know which project uses this mcal, is there a freertos project based on mcal? The MCAL drivers and examples are baremetal for AM62P, ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

Regarding UC3854 and UCD3138 used in the PMP20873 development board, we noticed that they both have three inputs: input voltage, input current, and output voltage. So what are the advantages and ...

We use the MMWCAS-DSP-EVM with the MMWCAS-RF-EVM (AWR1243 cascaded 4-chip radar module). Using MATLAB software, we plot range-Doppler maps by processing the captured data stored in bin files (outputs ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

We are working on DRA821U CPU with Linux SDK 09.02, we are facing issue with sd voltages switching in uboot, Here is the senario,initially detects with UHS mode, but once we launch "mmc rescan" again ...

Refer to bsl_software_invoke_app_demo_uart_LP_MSPM0G3507_nortos_ticlang, we want to duplicate the same method to enter BSL mode by invokeBSLAsm() on G3107. But MCU ...

we are trying to add LAN9374 6 port ethernet switch to interface with the RGMII2. we have connected the spi0 of the am625 to the lan9374. in device tree under spi0 we have added a node for the lan9374 ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I read that the packet sniffer 2 software contains the firmware that enables CC13xx launchpads to be used as capture device. Source: https://dev.ti.com/tirex/explore ...

I am encountering MibSpi3 RxBuf value not consistent with the SPI log. My situation is: the SPI3 is shared between TI TPS65381A-Q1 (psu) and Microchip MCP3208 (adc), and we implemented semaphore for ...

I wonder should we consider DC bias for the values of the capacitors on Table 7-1? If so, we should use larger capacitor values than listed on the table? I'm not sure I understand your concern with DC ...